Extron electronics XMP 240 C AT User Manual page 25

If only pushing selected presets, select them in the dialog box shown in the figure
below.
Figure 22. Preset Selection Dialog Box
4. Once a push or pull is completed, the current state of the connected XMP 240 C AT
is displayed in the DSP Configurator status panel and the device is ready for further
configuration.
Exit Live Mode and Enter Emulate Mode
1. Click the button in the DSP Configurator menu bar (see figure 23,
Emulate
Alternatively, select
Tools > Disconnect from Device
Figure 23. Emulate Button
2. Click to confirm.
OK
Figure 24. Confirm Disconnect
or press <F6> on the keyboard.
XMP 240 C AT • DSP Configurator Software
).
1
19