Table of Contents
Advertisement
Creating Subscriptions Between Transmitters and Receivers
1.
Ensure the control computer and XMP 240 C AT are connected to the same network.
2.
From the start menu select:
All Programs > Audinate > Dante Controller > Dante Controller
The
Dante Controller - Network View
Dante Controller auto-discovers Dante devices on the network and advertises itself to
allow other Dante-enabled devices to communicate with it. Transmitters connect to
receivers using the subscription matrix.
Figure 134.
Routing Tab of Network View Screen
3.
To show the transmitters of a Dante device, click the
in the
Dante Transmitters
changes to a
sign when the device expands.
–
4.
To show the receivers of a Dante device, click the
the
panel, such as
Dante Receivers
5.
Click the intersection of the desired subscription between a transmitter and a
receiver (
).
3
Example: The mic/line input transmitters of the
are routed to the AT input receivers of the
AXI22D-ConfRm2
A check mark at the intersection indicates the subscription is made. A check mark also
appears next to the receiver channel.
NOTE: A receiver can subscribe to only one transmitter. A transmitter can subscribe
to multiple receivers.
screen opens.
+
panel, such as
AXI22D-ConfRm1
+
box next to the desired device in
XMP240CAT-MainRack
AXI22D-ConfRm1
XMP 240 C AT • Dante Controller
box next to the desired device
(see figure 134,
). The
1
(
).
2
and
.
XMP240CAT-MainRack
+
99
Advertisement
Table of Contents
