Live And Emulate Panel - Extron electronics XMP 240 C AT User Manual

Live and Emulate Panel

The and
Live
displays transmit activity (Tx) and receive activity (Rx) when in Live mode.
Figure 18.
Emulate Mode
While in Emulate mode, DSP Configurator is functioning in an "offline" state. Changes made
to the configuration file are not applied to a XMP 240 C AT.
In Emulate mode, the user can create and configure the software as though a device was
connected, except for any actions that require direct connection to the device or information
that is stored only on the device. Once configuration is complete, the user can switch to
Live mode and apply the configuration to the device or save the configuration file to be
loaded onto one or multiple devices at a later time.
Creating configuration files in Emulate mode saves time by not requiring a device to be
connected or present in order for the bulk of DSP configuration to be completed.
NOTE: Not all menu options or actions are available in Emulate mode.
Live Mode
Enter Live mode to connect to a XMP 240 C AT and push or pull configurations between the
device and host PC. In Live mode, changes made in DSP Configurator are directly applied
to the XMP 240 C AT. Additionally, presets and macros can be created and stored on the
device.
When entering Live mode, the user is prompted with the
Connect to a XMP 240 C AT in Live Mode
1. Click the
Alternatively, select
Connect to device
Figure 19.
2. Connect to the XMP 240 C AT.
a. To connect via TCP/IP (recommended):
Click the
Hostname or IP Address
Password
b. To connect via USB:
Click the
drop-down menu (
c. To connect via RS-232:
Click the
to on the host PC from the
buttons allow users to switch between Live and Emulate mode and
Emulate
Mode Panel
button in the menu bar of DSP Configurator (see figure 19 ,
Live
Tools > Connect to Device
dialog box opens.
Live Button
tab in the dialog box. Enter the IP address of the device in the
TCP/IP
field. If necessary, enter the device password in the
figure 20,
field (see
a
tab in the dialog box. Select the device from the
USB
).
b
tab in the dialog box. Select the com port the device is connected
RS-232
Com Port
Connect to device
or press <F6> on the keyboard. The
on the next page).
drop-down ( ).
c
XMP 240 C AT • DSP Configurator Software
dialog box.
).
1
USB Devices
17