Downloading And Installing Dante Controller; Configuring The Xmp 240 C At In Dante Controller; Device Name - Extron electronics XMP 240 C AT User Manual

Downloading and Installing Dante Controller

Dante Controller from Audinate is required to route transmitters and receivers and can be
used to configure Dante settings and monitor performance. Install Dante Controller on a PC
running Microsoft
to download the software, see the Dante Controller product page at
To download Dante Controller:
1.
2.
3.
4.
5.
The installed Dante Controller program files are saved in:
C:\Program Files (x86)\Audinate\Dante Controller\DanteController.exe
Configuring the XMP 240 C AT in Dante Controller
Use a standard Ethernet cable to connect the XMP 240 C AT to a Dante network via the
rear panel AT port (see
device.

Device Name

Multiple devices on the same Dante network can present difficulty in identifying individual
devices. To avoid confusion and difficulty, ensure the following steps are taken:
•
•
•
•
ATTENTION:
In Dante Controller, a device can be renamed to identify the device on the audio network.
The default device name of the XMP 240 C AT consists of the model name, followed by
the last six characters of the Dante interface MAC address (for example,
addition to renaming the device, individual Transmitter (Tx) and Receiver (Rx) channels can
be renamed.
The Dante device name must be set before making any connections to other devices on the
Dante network. Renaming a device after making connections removes existing connections
to and from that device. Refer to
the next page for renaming procedure.
Windows 7 or newer. For full details about computer requirements and
® ®
From www.extron.com, hover over the
From the Featured Software
From the
Dante Controller
Select to run the Dante Controller installer. Select
Run
at a later time.
If you choose to run the file, follow all prompts. If you saved the file, click the saved file
to begin installation when ready.
Rear Panel Features and
Connect devices to the Dante network one at a time.
Rename each device before making audio connections in Dante Controller.
Rename each device with a unique and meaningful identifier.
Rename each device before the next device is connected to the Dante network.
• It is essential that a Dante device be named before audio subscriptions with other
devices are established. Existing subscriptions are removed when a device is
renamed.
• Il est essentiel d'identifier un appareil Dante immédiatement après sa connexion
au réseau Dante et avant tout établissement de connexion audio avec d'autres
appareils. Les connexions existantes sont supprimées dès qu'un appareil est
renommé.
tab at the top of the page.
Download
list, select
Dante Controller
product page, click the blue
Save
Cabling,
Renaming the XMP 240 C AT in Dante Controller
XMP 240 C AT • Dante Controller
.
www.extron.com
.
button.
Download
to save the install file to run
.
on page 5) and power the
C
). In
XMP240-0ee8ee
on
90