Extron electronics XMP 240 C AT User Manual page 115

Command
Asynchronous Macro Responses
Macro started
Macro finished
Macro failed
Macro killed
KEY:
X6( = Macro number
= Macro status
X7)
Dante Control and Configuration
The following commands configure the XMP 240 C AT to listen for and pass through SIS commands meant for
Extron AXI 02 AT, AXI 22 AT, and AXI 44 AT endpoints.
NOTE: The XMP must be set to Verbose mode 2/3 when using the Dante Control and Configuration
commands.
Query available remote
devices
Enable remote
connection for listening
Read remote
connection listening
status
Query remote devices
being listened to
Send command to
remote device
KEY:
= Dante Device Name
X17&
X19* = SIS command
X19( = SIS command response
X22@ = Extron Remote Connection
Mode
ASCII command
(host to device)
1 through
= Macro idle
0
E }
A EXPR
E X17& X22@ }
C * EXPR
E X17& }
C EXPR
E }
L EXPR
X17& X19* }
{dante@ : }
example command:
{dante@AXI02-XTP-
RoomA:wg40000*10AU|}|
Device names are not case sensitive
SIS command to be sent to remote dante-controlled device
Response from remote dante-controlled device, tagged by XMP
0 = Disabled
1 = Enabled
Response
(device to host)
X6(]
McroSTARTED
X6(]
McroFINISHED
X6( X7)]
McroFAILED *
X6( X7)]
McroKILLED *
64 . Response will be padded with a leading 0.
X17&]X17&] ]]
...
X17& X22@]
ExprC *
X22@]
X17&]X17&] ]]
...
example response:
{dante@AXI-XTP-RoomA}
]
DsG40000*10
XMP 240 C AT • Remote Control and Configuration
Additional description
Verbose 2/3:
•X17&]
ExprA
X7&] ]]
...
All listening disabled
when XMP Dante module
rebooted
Verbose 2/3:
X17& X22@]
ExprC *
Verbose 2/3:
•X17&]
ExprL
X17&] ]]
...
Verbose 2/3:
X17& X19(]
{dante@ }
120