Extron electronics XMP 240 C AT User Manual page 38

Compressor
Figure 50. Compressor Dialog Box
Compressor Channel Name — This name changes to match the default or user
1
defined input name.
Compressor Graph — Graphically displays compressor parameter settings.
2
Parameters can also be adjusted using this graph. Click and drag the dot within the
green area of the graph to adjust the compressor
outside the green box to adjust the compressor
Compressor Parameter List and Control — Lists all configurable parameters for
3
the compressor. Text fields are available to adjust
, and
Hold Time Release Time
and . Click a slider once and use the <
Release Time
keys to adjust the respective parameter in 1 ms steps. Select the
to provide a more natural implementation of compression when the signal reaches the
threshold.
Bypass Button — Bypasses the compressor. When the button is red, bypass is
4
enabled.
Set Defaults Button — Resets all compressor parameters to their default values. To
5
view individual parameter default values, see the DSP Configurator Help file by clicking
the button (
Dynamics Help
OK Button — Confirms changes made to the contained parameters and closes the
6
Compressor dialog box.
Cancel Button — Reverts any changes made to the contained parameters back to
7
their states when the current instance of the
closes the dialog box.
Dynamics Help Button — Opens the
8
DSP Configurator Help file for further assistance in operating dynamics processors.
Compressor Channel Name
1
Compressor Graph
2
Compressor Parameter List and Control
3
Bypass Button
4
Set Defaults Button
5
OK Button
6
Cancel Button
7
Dynamics Help Button
8
Threshold
.
Ratio
Threshold
. Click and drag sliders to adjust
Left Arrow
) to open the
About Dynamics
8
Compressor
Dynamics Operation
XMP 240 C AT • DSP Configurator Software
. Click and drag the dot
, , ,
Ratio Attack Time
,
Attack Time Hold Time
> and <
Right Arrow
checkbox
Soft Knee
topic.
dialog box was opened and
topic of the
,
>
32