Table of Contents
Advertisement
RS-232 Port
The XMP 240 C AT has a serial port that can be connected to a host device such as a
computer running either the DataViewer or HyperTerminal utilities. The port makes serial
control of the XMP 240 C AT possible.
The XMP 240 C AT uses the following RS-232 protocols:
•
38400 baud
•
8 data bits
NOTES:
•
The rear panel configuration port requires 38400 baud communication. This
speed is higher than most other Extron products. The XMP 240 C AT control
software automatically sets the connection for the appropriate speed. When using
DataViewer or similar application, make sure the host PC or control system is set
for 38400 baud.
•
See
connecting to the RS-232 port.
LAN Port
The XMP 240 C AT can be connected to an Ethernet LAN or WAN. Communication
between the device and the controlling device is via Telnet (a TCP socket using port 23). The
Telnet port can be changed, if necessary, via SIS. This connection makes SIS control of the
device possible using a computer connected to the same LAN or WAN. The SIS commands
and behavior are identical to the commands and behavior the product exhibits when
communicating by serial port or USB.
The XMP 240 C AT LAN 1 port defaults are as follows:
IP Address
192.168.254.254
The Ethernet cable can be terminated as a straight-through cable or a crossover cable and
must be properly terminated for your application.
•
Crossover cable — Direct connection between the computer and the XMP 240 C AT.
•
Straight-through (Patch) cable — Connection of the XMP 240 C AT to an Ethernet
LAN.
Pins:
12345678
Insert Twisted
Pair Wires
RJ-45
Connector
Figure 138.
•
No parity
•
No flow control
Rear Panel Features and Cabling
Subnet Mask
255.255.255.0
Crossover Cable
(for direct connection to a PC)
End 1
Pin
Wire Color
Pin
1
white-orange
1
2
orange
2
3
white-green
3
4
blue
4
5
white-blue
5
6
green
6
7
white-brown
7
8
brown
8
T568A
A cable that is wired as TIA/EIA T568A at one
end and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable.
RJ-45 Ethernet Connector Pin Assignments
XMP 240 C AT • Remote Control and Configuration
•
1 stop bit
on page 4 for additional details on
Default Gateway
0.0.0.0
Straight-through Cable
(for connection to a switch, hub, or router)
End 2
End 1
Wire Color
Pin
Wire Color
white-green
1
white-orange
green
2
orange
white-orange
3
white-green
blue
4
blue
white-blue
5
white-blue
orange
6
green
white-brown
7
white-brown
brown
8
brown
T568B
T568B
A cable wired the same at both ends is called
a "straight-through" cable because no pin/pair
assignments are swapped.
DHCP
OFF
End 2
Pin
Wire Color
1
white-orange
2
orange
3
white-green
4
blue
5
white-blue
6
green
7
white-brown
8
brown
T568B
104
Advertisement
Table of Contents
