Connecting The Interface Cable - SATO S84-ex Operator's Manual

2 Installing the Product

2.4 Connecting the Interface Cable

The connection of the interface cable is explained as follows:
2.4.1 Available Interfaces
This product supports the following interfaces.
Furthermore, a product connected with multiple interface cables can continue to operate when receiving
data.
*You cannot receive data from more than one interface at a time.
*You cannot use the USB interface if you have installed the optional wireless LAN.
• USB
• LAN
• RS-232C
• IEEE1284
• Bluetooth
• Wireless LAN (WLAN)
• External signal (EXT)
Note
The wireless LAN interface and Bluetooth interface are optional.
2.4.2 Interface Connections
1
Make sure that the product, host computer and applicator are powered off.
Set the power switch of the product to the "O" position.
2
Connect the product to a host computer with one or more of the available interface
connections.
Use a cable that is compatible with the standard of the interface board as stated in
Interface Specifications. Check the orientation of the connector before you make the connection.
32
S84-ex/S86-ex Operator Manual
Host computer
Applicator
Section 9.12