Connecting The Power Cable - SATO TH2 Series Operator's Manual

Section 2: Installation
2.4 CONNECTIONS (cont'd)

2.4.3 Connecting the Power Cable

Warning
• Be sure to connect the ground wire. Failure to do so may cause an electric shock.
• Do not operate the power button or plug in/ unplug the power cable while your hands are wet.
Doing so may cause an electric shock.
Caution
The power cable and the AC adapter provided with this printer are for use with this printer only.
They cannot be used with other electrical devices.
1.
Connect the supplied AC power plug to the supplied AC
adapter.
2.
Connect the DC power plug from the AC adapter to the
DC input power connector on the back of the printer.
Make sure the flat side of the DC power plug is facing
upward. Secure the printer with one hand, and insert the
cable firmly.
3.
Insert the AC power plug into a AC power outlet.
Make sure that the AC voltage of your region is within
the range of AC 100 to 240V, 50/60 Hz.
A 3-pin plug is attached to the power cord provided with
your printer. One of these pins is the ground wire.
You must use a 3-pin power outlet. The plug will not
work with a 2-pin power outlet.
Note:
The shape of the power plug may vary depending on the
location where the printer was purchased.
Page 2-8
AC adapter
AC power
plug
Flat side faces up
DC power plug
TH2 Series Operator Manual
DC input
power
conncetor