Rep 8.11 Sheet Feed Switch - 8830 And 8825 With Tag/Mod 90; Rep 8.12 Registration Pinch Rolls - Xerox 8825 Service Manual

REP 8.11 Sheet Feed Switch - 8830 and 8825 with Tag/MOD
90
Parts List on PL 8.4
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Latch the Xerographic Module at the Service Position
2. Remove the Media Transport Assembly
3. Remove the Fabric Guide (REP 8.9).
4. Remove the Pressure Plates (REP
5. Remove the Front Pivot Assembly using
6. Remove the Sheet Drive Roll (REP
7. (Figure 1): Remove the Sheet Feed Switch.
1
Disconnect the con-
nector
2
Squeeze the tabs
Figure 1 Removing the Sheet Feed Switch
Repairs and Adjustments
REP 8.11, REP 8.12
WARNING
(REP 9.2).
(REP 8.1).
8.5).
REP 8.2.
8.6).
3
Remove the Sheet
Feed Switch

REP 8.12 Registration Pinch Rolls

Parts List on PL 8.2
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: The art used for this procedure was developed for previous products and may not
match the 8825/8830 configuration exactly.
Removal
1. Latch the Xerographic Module at the Service Position
2. Remove the Media Transport Assembly
01/02
4-34
WARNING
(REP 9.2).
(REP 8.1).
8825/8830 Printer