Trace Function; Single Trace - Siemens SINAMICS DCM Operating Instructions Manual

Descriptions of functions
10.32 Diagnostics
10.32.5.2

Trace function

Single trace

You can use the trace function to record measured values over a defined period, depending
on trigger conditions. Alternatively, the measured values can also be recorded using
immediate recording.
In the STARTER commissioning tool you can parameterize the trace function by using the
"Trace" parameterizing screen form.
Calling the "Trace" parameterizing screen form
In the STARTER commissioning tool, click the
The "Trace" parameterizing screen form is then displayed.
Example:
Figure 10-93 Trace function
Parameterizing and operating the trace function
Note
Detailed information on how to parameterize and operate the trace function is available in
the STARTER online help in Chapter "Trace, measuring functions and automatic controller
setting".
604
symbol (device trace-function generator).
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A