Installation; Introduction; Installation Position - Eaton PowerXL DA1 Series Installation Manual

3 Installation

3.1 Introduction

3.2 Installation position

This chapter provides a description of the mounting and the electrical
connection for the DA1 variable frequency drive.
￫
While mounting and/or assembling the variable frequency drive,
cover all ventilation slots in order to ensure that no foreign
bodies can enter the device.
￫
Perform all installation work only with the specified appropriate
tools and without the use of force .
￫
For information on how to install DA1 variable frequency drives
with the various enclosure versions, please refer to the
following instruction leaflets:
• IL04020010Z (IP20 in FS2, FS3)
• IP040049ZU (IP20 in FS4, FS5)
• IL04020012Z (IP20 in FS8)
• IL04020011Z (IP55 in FS4, ..., FS7)
• IL04020015Z (IP66 in FS2, FS3)
DA1 variable frequency drives are available in three enclosure versions:
• IP20 / NEMA 0 protection for use in control panels,
• IP55 / NEMA 12 protection,
• IP66 / NEMA 4X protection.
The IP55 and IP66 enclosure versions provide protection against moisture
and dust, allowing for use under harsh conditions in indoor environments.
Without the required additional measures, using the device in the following
environments is strictly prohibited:
• Explosion-proof areas
• Environments with damaging substances:
• Oils and acids
• Gases and fumes
• Dust
• Radiated noise
• Environments with mechanical vibration and impact loads that go
beyond the requirements of EN 50178.
• Areas in which the variable frequency drive takes care of safety
functions that must guarantee machine and personnel protection.
DA1 Variable Frequency Drives 08/18 MN04020005Z-EN www.eaton.com
3 Installation
3.1 Introduction
79