Eaton PowerXL DA1 Series Installation Manual page 136

4 Operation
4.3 Commissioning with control signal terminals (default settings)
Connection example for three-phase motor
L1 L2 L3 PE
L N PE
L1/L L2/N L3
U V W
M

3 ~
132
Connection example for three-phase motor
1 2 3
STO+
12
13
STO-
5 6 7
▶ For simple commissioning with the preset default settings, connect the
variable frequency drive as shown in the connection example above.
The potentiometer should have a fixed resistance (connection to control
signal terminals 5 and 7) of at least 1 kΩ, up to a maximum of 10 kΩ.
A standard fixed resistance of 4.7 kΩ is recommended.
Make sure that the enable contacts (FWD/REV) are open and the STO is
connected correctly before switching on the mains voltage.
￫
If the connections for the setpoint value potentiometer cannot
be clearly allocated with terminals 5, 6 and 7, you should set the
potentiometer to about 50 % before giving the start enable
(FWD/REV) for the first time.
When the specified supply voltage is applied at the mains connection
terminals (L1/L, L2/N, L3), the switched-mode power supply unit (SMPS) in
the DC link will be used to generate the control voltage and light up the
7-segment LED display (STOP).
At this point, the variable frequency drive will be ready for operation (correct
operating status) and in Stop mode.
DA1 Variable Frequency Drives 08/18 MN04020005Z-EN www.eaton.com
Terminal Name
L1/L Single-phase mains
connection
L2/N
(DA1-12...)
L3 –
 Ground connection
1 Control voltage +24 V (output, maximum 100 mA)
2 FWD, Start enable clockwise rotating field
3 REV, Start enable left rotating field
U Connection for three-phase ac motor
(three-phase motor)
V
W

5 Control voltage +10 V (output, maximum 10 mA)
6 Frequency reference value f-Set (Input 0 – +10 V)
7 Reference potential (0 V)
12 Safe Torque Off +
13 Safe Torque Off -
Three-phase mains
connection(DA1-3...)