Eaton PowerXL DA1 Series Installation Manual page 107

￫
PE earthing connection with ring cable lugs on the right side.
￫
Terminals +DC and -DC have the same function as terminals
DC+ and DC-.
Table 9: Terminal bolt (FS6, FS7)
Description
Connection with three-phase
supply voltage:
• DA1-32... (200 - 240 V)
• DA1-34... (380 - 480 V)
• DA1-35... (500 - 600 V)
L1 L2 L3
PE L1 L2 L3
Figure 66: Connection terminal bolts for sizes FS6 and FS7
The PE earthing connection is made with ring cable lugs and the bolts on the
left and right sides of the enclosure.
The terminal bolts for an external brake resistor are located under the cover
marked with + and BR.
￫
Stud terminal + has the same function as terminal DC+.
￫
If the device is installed in a control panel, the lower blanking
plate and the front enclosure cover must not be installed.
Without the cover, the DA1 variable frequency drive will have
IP40 protection.
DA1 Variable Frequency Drives 08/18 MN04020005Z-EN www.eaton.com
optional: External braking
resistor (R )
B
+
BR - U V
+
BR
R
B
M
3 ~
3.6 Electrical Installation
Connection for three-phase motors
(motor voltage = supply voltage)
W
PES
3 Installation
103