Control Panel Installation - Eaton PowerXL DA1 Series Installation Manual

3 Installation
3.3 Assembly

3.3.4 Control panel installation

88
If the DA1 variable frequency drive is installed into a control cabinet, ensure
that it is installed with structural stability.
It is preferable to install it on a rear wall. Moreover, the top of the cabinet
should be fastened to the wall and the two front corners should be fastened
to the floor.
If the cabinet is set up in a freestanding configuration, all four corners must
be fastened to the floor.
①
①
Figure 52: Stable control panel setup
￫
Heavy accessories such as motor chokes and sine wave filters
should always be installed on the control panel's base plate.
DA1 Variable Frequency Drives 08/18 MN04020005Z-EN www.eaton.com