Eaton PowerXL DA1 Series Installation Manual page 109

3.6.1.4 Connection terminals on frame sizes FS2 and FS3 with IP66
1
90°
2
Table 11: Connection terminals (FS2, FS3)
Connection terminals

L1/L L2/N L3
PE L N

L1/L L2/N L3
PE L1 L2 L3

U V
PES
M
3 ~
￫
Terminal + has the same function as terminal DC+.
DA1 Variable Frequency Drives 08/18 MN04020005Z-EN www.eaton.com
On FS2 and FS3 frame sizes with IP66
protection, the connection area is located
behind the lower enclosure cover.
To open the cover, release the two
latches by turning them counterclockwise
(90 degrees) so that they are in a vertical
position [1].
Once the latches are released, you can lift
the cover off forwards [2].
Figure 69: Remove enclosure cover (IP66)
Description
Connection with single-phase supply voltage
• DA1-12... (200 - 240 V)
Connection with three-phase supply voltage:
• DA1-32... (200 -240 V)
• DA1-34... (380 - 480 V)
• DA1-35... (500 - 600 V)
Motor connection for three-phase motors:
(motor voltage = supply voltage)
W + BR
optional: External braking resistor (R
R
B
3 Installation
3.6 Electrical Installation
)
B
105