Ip55 Protection Ip55 (Fs4, Fs5, Fs6, Fs7) - Eaton PowerXL DA1 Series Installation Manual

1.5.3 IP55 protection IP55 (FS4, FS5, FS6, FS7)

The following drawing serves as an example showing the designations used
for the elements in DA1 variable frequency drives with a frame size of FS4
and IP55 protection.
⑩
Figure 11: DA1 designations (here: FS4, IP55)
a Operating unit with 5 control buttons and OLED display
b Slot for fieldbus connection or expansion module
c Control signal terminals and relay terminals (plug-in)
d Connection terminals in power section
e Device fan
f Fixing holes
g Blanking plate for installing cable glands for IP55 protection
(without blanking plate: IP40 protection)
h Retainer for the control section connection cables
i Communication interface (RJ45)
j Enclosure cover (connection terminals)
The info card is located inside the lower enclosure cover ⑩
(removed in the figure above).
Blanking plate
Figure 12: Blanking plate with holes for cable glands (FS4, FS5)
￫
The equipment supplied with frame sizes FS4 and FS5 includes
an additional blanking plate ⑦ that already has holes for the
cable glands.
DA1 Variable Frequency Drives 08/18 MN04020005Z-EN www.eaton.com
⑨
⑧
⑦
⑥
1 DA1 device series
1.5 Designation
①
②
③
④
⑤
27