Emc Cable Brackets - Eaton PowerXL DA1 Series Installation Manual

3 Installation
3.5 EMC installation

3.5.6 EMC cable brackets

96
The DX-EMC-MNT-... cable brackets enable the cable routing and cable catch
in the connection area of the DA1 variable frequency drive in sizes FS2 and
FS3 of protection type IP20. The cable brackets are installed on the mains
connection side (DX-EMC-MNT-...N) and the motor side (DX-EMC-MNT-...M)
of the variable frequency drive above the mounting holes and connected to
the ground connection
The cable brackets' integrated hole pattern (M4 screw thread) makes it
possible to secure the cables being connected and relieve any strain on them
by using the corresponding cable clamps. It also makes it possible to have a
360° EMC connection (PES) in the case of screened cables.
These cable brackets are made of galvanized sheet steel.
Figure 59: DX-EMC-MNT-...N (left), mains and DX-EMC-MNT-...M (right), motor, cable
brackets
￫
For more information and technical data on DX-EMC-MNT-...
EMC cable brackets, please refer to instructional leaflet
IL040010ZU.
￫
DX-EMC-MNT-... EMC cable brackets are sold as individual
units. There are different brackets for each DA1 variable
frequency drive frame sizes (FS2 and FS3).
Thecable clamps and their fixing screws are included in the
equipment supplied with the cable brackets.
Cable bracket Frame size DA1
DX-EMC-MNT-2N FS2
DX-EMC-MNT-2M FS2
DX-EMC-MNT-3N FS3
DX-EMC-MNT-3M FS3
DA1 Variable Frequency Drives 08/18 MN04020005Z-EN www.eaton.com
of the variable frequency drive.

Cable clamps
Number / designation
1/Mains connection
3/control cables, motor connection, external braking resistor
1/Mains connection
3/control cables, motor connection, external braking resistor