Eaton PowerXL DA1 Series Installation Manual page 91

▶ To do this, place the variable frequency drive on the mounting rail from
above [1] and press it down until it snaps into place [2].
1
2
Figure 50: Fixing on mounting rails
Dismantling from mounting rails
▶ To remove the device, push down [2] on the clip being held by a spring
force [1]. For this, there is a marked recess on the bottom edge of the
device.
For unlocking, it is recommended that a screwdriver with a flat head
(e. g. head width 5 mm) is used.
EMC
VAR
3
2
Figure 51: Dismantling from mounting rails
▶ Now pull the lower edge away from the mounting surface (forwards) [3]
before lifting the variable frequency drive off the mounting rail.
DA1 Variable Frequency Drives 08/18 MN04020005Z-EN www.eaton.com
f 5 mm
(f 0.197")
1
3 Installation
3.3 Assembly
EMC
VAR
87