Advertisement
15-16
GROUP
15-
LIGHTING SYSTEM, HORNS AND INSTRUMENTS
FIG. 20- Speedo Cable to Speedo Connection.
SPEEDO
CABLE
DISCONNECT
FROM SPEEDO HEAD
1. Remove the crash pad and
cover (from right hand
side).
2.
Using a long screw driver or
solid rod depress the release tab and
pull the cable away from the speedo
head.
(Fig. 20).
FUEL & TEMPERATURE GAUGES
I
.
Remove the instrument cluster
as previously outlined.
2. Remove the two upper screws
retaining the lenses and the two
screws holding the two halves of the
cluster together.
3. From the front of the gauges,
remove the two screws retaining the
fuel gauge mask, unclip the mask
from the temperature gauge mask and
remove it from beneath the needle.
4. Remove the terminal speed nuts
retaining the gauges to the rear half
of the canister and remove the
gauges.
NOTE: The fuel gauge mask must be
removed before the temp gauge or
mask can be removed.
FUEL & TEMPERATURE GAUGES
G.T.&G.S.
1. Remove the instrument cluster
housing (3) retaining screws and lay
the housing toward the steering
column.
2. Remove the gauge wiring and
disconnect the warning lamp holders
from the housing.
A
~·:_.h-k-··
~~r
ALL FALCON MODCL5 UCEPT 54H
WIN
IN DIRCCTI(.W
Lit
""~'JW
)'
S/llfJWfN6 €J..R.T,.,IC.III..
CONNt.Cflt..-~W
~
'iCtkJIMD
1"'.-H
.W.SfJUI..AIIIJ/N
(AtJI.Jin()lllltt ICJ
;TA-N/)NO(I~HK.)
~I
T
WAIININ* I.. AMI' .J0CK£r A.S.SY
.J.
A r
IVVItii6611£1J LDCATIONS INACCOifiJANCI
¥lii'Jt
/ltiMIN4 1/JIHr/"CArN:IN J(NIDVl.6.
611.01111
:
@)
61..VC/WNI
T£ 4 61fiiN
~
&AC'If/,-ILI.OW~ #HEN
<!)
Wllnl # GIIIIIV
3. Remove the housing from be-
hind the steering column and remove
the gauge retaining screws.
4. Remove the gauges from the
housing.
FUEL & TEMPERATURE GAUGES
FAIR LANE.
l. Remove the instrument cluster
as previously outlined.
2. Remove the four screws attach-
ing the lens and cover to the
canister.
3. Remove the terminal speed nuts
from the gauges and remove the
gauges from the
canister.
SPEEDOMETER & TACHOMETER.
1. Remove the instrument cluster
and separate it as previously outlined
under fuel and temperature gauge
removal.
2. Remove two retaining screws
from the backs of the speedometer/
tachometer.
NOTE: On Fairlane remove fuel and
temperature gauges prior to attempt-
ing to remove the
speedometer.
3. Remove
the
speedometer
I
tachometer from the cluster.
PRINTED CIRCUIT.
Replacement of the printed circuit
can only be achieved once the gauges
-speedometer/tachometer have been
removed. Fig. 3 & 4.
@J
YILLOW/61..ACK 4 ILACK-{AIMOtfl rAN
WHIN
lf.IIO.
JIA 1" . , ,
r
WAif NINe .S~I,/ID DNL Y)
@
~IIN/.LACK 4 .LACK
FIG. 21 - Installation Drg. Cluster Housing.
Advertisement
