Advertisement
PART 7-2- C4 AUTOMATIC TRANSMISSION
7-79
STEP-1
STEP-2
INSTALL SPRING RETAINER
INTO OUTER RACE
STE
P-3
INSTALL 12 SPRINGS
FIG. 103
-One-Way
Clutch Installation
gear hub to output shaft retaining
ring
(Fig.
52).
20. Place thrust washers
Nos. 6
and 7 on the reverse
planet
carrier
(Fig.
105).
21.
Install the planet
carrier
in
the
reverse ring gear and engage
the
tabs of the carrier with
the
slots
in
the low-reverse drum.
22.
On the bench, install
the for-
ward clutch in the
reverse-high
clutch
by
rotating the units
to mesh
the reverse-high clutch plates
with
the splines of the forward clutch
(Fig. 106).
23. Using the end play check
reading that was obtained during
the transmission disassembly to
determine which No. 2 steel backed
thrust washer is required, proceed
as follows:
a. Position the stator
support
vertically on the work bench and
install the correct No. 2 thrust-
washer
or washer and spacer to
bring the end play within speci-
INSTALL INNER RACE
INSTALL 12 ROLLERS
01551-A
fications
.
b. Install the reverse-high
clutch
and
the forward clutch on the
stator
support.
c. Invert the complete unit mak-
ing sure that the intermediate brake
drum bushing is seated on the
for-
ward clutch mating
surface.
d. Select the thickest nylon
washer
(No. 1) that
can
be inserted between
the
stator support and
the inter-
mediate brake drum
thrust surfaces
and still maintain
a slight clearance.
Advertisement
