Advertisement
6-32
GROUP
6-GENERAL TRANSMISSION SERVICE
gear and install the 21 roller bearings
and a retainer washer in each end of
the gear.
REVERSE IDLER GEAR
BEARINGS
1. Slip the reverse idler sliding
gear off the reverse idler gear (Fig.
66).
2. Remove the dummy shaft, two
bearing retainer washers and the 44
roller bearings from the reverse idler
gear.
3. Coat the bore in each end of the
reverse idler gear with grease.
FIR ST AND SECOND SPEED CAM AND SHAFT
REVERSE GEAR CAM
~
/
ANDSHAF
T
~ ~
FIR ST AND SECOND SPEED SHIFT LEVER
SPEED CAM AND SHAFT I
~~@@~
~m}
FIG. 60A
-Gear Shift Lever Disassembled-Typical
SNAP RINGS
INPUT SHAFT
AND
BEARING
ROLLER BEARINGS
rr
1
'
·
v
I
BLOCKING RING
FIG. 608
-Input Shaft Gear Disassembled
INPUT SHAFT SEAL
1. Remove the seal from the input
shaft bearing retainer as shown in
Fig.
62.
2. Coat the sealing surface with
lubricant.
3. Install the seal as shown in
Fig. 63.
ASSEMBLY
4. Hold the dummy shaft in the
gear and install the 22 roller bearings
and the retainer washer in each end
of the gear.
5. Install the reverse idler sliding
gear on the reverse idler gear making
sure that the shift fork groove is
toward the front (Fig. 66).
Too/-7025 -G
OR 7025-B
5
INSTALLATION
FIG. 61
-Input Shaft Bearing
(Removal and Installation)
1. Coat the
countershaft gear
thrust surfaces in the case with a thin
film of lubricant and position a thrust
washer (Fig. 65) at each end of the
case.
FIG. 62
-Removing Input Shaft Seal
Advertisement
