Advertisement
PART 17-3-
DOORS, WINDOWS, TAILGATE
AND DECK LID
17-53
DECK LID HINGE OR
TORSION
BAR
REMOVAL
1. Prop the deck lid open.
2.
Mark the hinge position on the
lid
and on the mounting bracket for
reference
when a new hinge is in-
stalled.
3. Pry the anchor end of the
torsion
bar out of its adjustment
notch
(Fig.
14). Lower the deck lid
and from
inside the luggage compart-
ment
remove the bar.
4. Position
a cover under the hinge
edge of the
deck lid to prevent
paint damage. Remove
the hinge
attaching bolt from
the deck lid and
from the mounting
bracket, and
remove the hinge.
INSTALLATION
1. Position the
hinge, and partially
tighten the mounting
bolts.
2. Remove
the protective cover
and install the torsion
bar, reversing
the procedure in
step
3
above. The
FIG. 18-Deck Lid Lock Installation
1. Weatherstrip
-
Luggage
Compt. Door
2. Latch Assy - Luggage
Compt.
Door
3. Retainer
-
Luggage Compartment
Door Lock Cylinder
4. Pad- Luggage Compartment Door
Lock Cylinder
5. Extension- Luggage Compartment
Door Lock Cylinder
6. Lock Set
1. Striker- Luggage Compartment
Door Lock
farther rearward the anchor
end is
twisted,
the greater the tension.
3. Remove the prop and check
the lid
position.
After any necessary
adjustment, tighten the hinge attach-
ing
bolts.
DECK LID LOCK
1.
Unlock and open the deck
lid.
2. Remove the bolts retaining
the
lock assembly and remove the
lock.
3. Position the lock assembly
t<'
the deck lid and loosely install
the
retaining
bolts.
4.
Adjust the lock assembly and
tighten the bolts.
DECK LID LOCK CYLINDER
REMOVAL
1.
Open the deck lid and
remove
the lock assembly and the door
lock
extension.
2. Remove the sleeve
assembly re-
taining nut, lock washer, spacer, and
sleeve and cylinder
(Fig. 18)
3. To remove the lock cylinder
from the sleeve assembly, turn
the
key in the cylinder Vs turn clockwise
from the locked position, depress
the
cylinder retaining pin, and remove
the key and cylinder.
INSTALLATION
1. To install the lock
cylinder
and insert the cylinder into
the
sleeve assembly.
1. Position the sleeve assembly
turn the key in the cylinder Vs
turn
clockwise from the locked
position
spacer, and washer to the
deck lid
door and install the retaining
nut:
3. Position the door lock
exten-
sion, install the lock assembly
and
adjust it.
A Adhesive
-Apply
a .25
Max.
Bead
to Bottom of Weatherstrip Trough
B Adhesive
-Apply
a .093 approx.
Bead Under Outboard Lip of Luggage
Compartment Weatherstrip
After Installation of Weatherstrip in Trough.
Application of Adhesive Must
Extend Downward on Vertical Surface
as Shown in View
"A"
C Screw
&
Washer Assy
D Screw & Washer Assy
Advertisement
