Advertisement
PART 17-3-
DOORS, WINDOWS, TAILGATE AND DECK
LID
17-43
FIG.
9-
Back Window Installation---- Utility
4. Insert the draw cord in the
weatherstrip, and apply rubber lub-
ricant to the weatherstrip surfaces
that will contact the back window
opening flange.
5. Using a sealer gun, apply a
bead of sealer completely around
the back window openin!;
.
6. Position the window assembly
in the body opening
.
With a helper
applying hand pressure from the
outside, use the draw cord to pull
the lips of the weatherstrip over
the window opening flanges
.
7.
Clean the window and
mouldings.
TAILGATE GLASS
REMOVAL
1. Open the tailgate and remove
the trim panel and watershield.
2. On
power
operated
models,
turn the right hand side lock pivot
to the closed position and raise
the window partially out of the
gate. On manually operated models
wind the window partially out using
the handle.
3. Remove
the
regulator
arms
from the window regulator channel
and remove the window
assembly.
INSTALLATION
1. With a glass remover tool, r
e-
move the glass lower retainer and
channel assembly and then clean
the glass groove.
2. Position the weatherstrip into
the glass lower channel. Install the
weatherstrip and
channel
to
the
g-lass.
3. Position the window assembly
in the gate and install the regula-
tor arms to the regulator channel.
Lower the window into the tailgate.
4. Install the tailgate watershield
and trim panel.
TAILGATE WINDOW
HANDLE
AND
LOCK
CYLINDER-MANUAL
REMOVAL
Refer to
Fig.
12 for
views
of th
e
assembly.
S
EC
A
SEC
8
6
CIR CLe(.
1.
Remove
the
taiigate
trim
J:anel
and watershield
and align
a ccess holes in regulator asemblsy
with those in tailgate inner panel.
2. Unscrew
the
two
nut
and
washer
assemblies
fastening
the
window handle assembly to the tail-
gate and remove the handle assem-
bly, the regulator stem socket, the
spring and the rubber
pad.
3.
To remove the lock cylinder,
turn the key in the cylinder to align
the cylinder locking pin with the
access hole in the handle assembly.
Depress the locking pin and remove
the lock cylinder.
INSTALLATION
I.
To replace the Jock cylinder,
transfer the 0 ring, and then with
the key in the cylinder, install the
lock cylinder in the handle assem-
bly.
2. Relocate the parts removed
and replace the two nut and washer
assemblies and tighten securely.
Advertisement
