Advertisement
SWITCHES, CIRCUIT BREAKERS AND FUSES
EJ
REMOVAL AND INSTALLATION
HEADLIGHT SWITCH
1. Disconnect the battery ground
cable.
2. Prise the switch forward from
the instrument
cluster.
3. Disconnect wiring and remove
the switch.
4. Connect wiring to the switch
connections.
5.
Press the switch assembly into
the aperture.
HEADLIGHT BEAM
SELECTOR SWITCH
Lay the ftoor mat back from the
area of the switch, and remove the
mounting screws
(Fig. 15).
Discon-
nect the wire terminal block from the
switch.
To install the switch, connect the
terminal block to the switch and in·
stall the switch to the floor. Replace
the ftoor mat.
STOP LIGHT SWITCH
1. Disconnect the wires at the
connector.
2. Release the locknut (pedal side)
and withdraw the switch.
3. Reverse the above procedure to
replace the
switch.
4. Adjust the switch as in section 1.
DOME LIGHT SWITCH
The dome light switch is incor-
porated in the panel lamp switch. It
is actuated by rotating the switch
control wheel to the right when once
the panel lamps have reached full
brilliance
.
The further rotation of the
wheel switches the dome lamp on.
The dome lamp also acts as a
courtesy lamp actuated by switches
tn the door
pillars.
IGNinON SWITCH
AND
LOCK CYUNDER
1. Disconnect the negative cable
from the battery.
FIG.
15
-
Headlight Beam
Selector Switch
2. Remove the column from the
vehicle.
3. Remove
the
steering
lock
shroud and shift tube. Page 3 - 38
4. Cut slots in the steering lock
attaching bolts with a hacksaw and
remove the bolts with a screw driver
or hammer and centre punch.
5.
Rotate the lock around the
column tube until one end of the
base clears the aperture, lift the lock
from the column.
6. Place the steering/ignition lock
assembly into the steering column
7. Engage new recessed bush in the
shear head bolts and tighten them
evenly until the heads shear off.
Install shift tube.
8. Assemble the shroud to the
column.
9. Assemble the column to the
vehicle.
LOCK BARREL REPLACEMENT.
1. Remove the steering/ignition
lock shroud lower attaching screw
from beneath the
shroud.
2. Turn the ignition key to the
off or on
position.
3. Push a 0.062 dia. pin into the
lock
thiough
the
shroud lower
mounting hole to raise the barrel
locking pin and remove the barrel
Fig.
16.
15-13
FIG. 16- Typical Ignition Switch
Removed.
4. Align the barrel tongue and
aperture and assemble the barrel
to the lock and raise the barrel
locking pin by turning the key to the
start
position.
5. Assemble the lock shroud lower
attaching
screw.
WINDSHIELD WIPER SWITCH
1. Disconnect the battery cable.
2. Prise
the switch from the
instrument cluster.
3. Disconnect wiring and remove
the switch.
4. Connect wiring to the switch
connections.
5. Press the switch assembly into
the aperture
.
NEUTRAL
START SWITCH
See group 7 for replacement of
the neutral start switch on cars
equipped with automatic transmis-
sions.
BACK-UP
LIGHT SWITCH
1. Remove the two wires from
the switch.
2. Loosen the retaining clamp or
locknuts.
3. Remove the switch.
Advertisement
