Advertisement
7-74
GROUP 7-AUTOMATIC TRANSMISSION
EXTERNAL SNAP RING
INPUT SHELL
~
SUN GEAR
THRUST WASHER NO
.
5
FIG. 84- Input Shell and Sun Gear Disassembled
FIG. 85 - Reverse Ring Gear and
Hub Disassembled
FIG. 87- Removing or Installing
Retaining Ring
ERNOR fi
OUS IN(,
GOVERNOR
ASS
EMBLY
-
7(063
01907-B
FIG. 86 - Governor and Oil Distributor
is bottomed in the groove of the
ring gear.
4. Install the front clutch hub
retaining snap ring. Make sure the
snap ring is fully seated in the snap
ring groove of the ring gear.
INPUT SHELL AND SUN GEAR
1. Remove the external snap ring
from the sun gear (Fig. 83).
2. Remove thrust washer No. 5
from the input shell and sun gear
(Fig. 84).
3. From inside the input shell,
remove the sun gear. Remove the
internal snap ring from the sun
gear.
4. Install the internal snap ring
on the sun gear. Install the sun gear
in the input shell.
5. Install thrust washer No. 5 on
the sun gear and input shell (Fig.
84).
6. Install the external snap ring
on the sun gear
(Fig. 83).
REVERSE RING GEAR
AND HUB
1.
~emove
the hub retaining
snap rmg from the reverse ring
gear.
2. Remove the hub from the
reverse ring gear
(Fig.
85).
3. Install the hub in the reverse
ring
gear.
Make sure the hub is fully
seated in the groove of the ring gear.
4. Install the snap ring in the
reverse ring gear. Make sure the
snap ring is fully seated in the snap
ring groove of the ring gear.
GOVERNOR AND OIL
DISTRIBUTOR
1. Remove the rings from the
governor oil distributor
(Fig.
86).
2. Remove the governor housing
to
distributor
attaching
bolts.
Remove the governor from the oil
distributor. Remove the governor
oil screen.
3. Remove the primary governor
valve
retaining
ring
(Fig. 87).
Remove the washer, spring, and
primary governor valve from the
housing.
4. Remove the secondary govern-
or valve spring retaining clip,
spring, and governor valve from
the housing.
5. Install the secondary governor
valve in the housing. Install the
spring and retaining
clip.
Make
sure the clip is installed with the
small concaved area facing down-
ward, to hold the spring in the
correct position.
6. Install the primary governor
Advertisement
