Advertisement
16-6
GROUP
16- VENTILATING AND HEATING
EJ
REMOVAL AND INSTALLATION
HEATER ASSEMBLY REMOVAL
1. Drain the Cooling System.
2. Remove the glove box.
3. Disconnect
the temperature/
mode
and
left
hand air
duct
control
cables.
4.
Remove
the
hoses
from
the
heater pipes
in
engine compartment.
5.
Disconnect the wiring plug at
the heater assembly.
6.
Remove
the
left hand air duct
and the
demist nozzle retaining clips.
7.
Disconnect the
feed
wire at the
top of
the heater
above the
fan
.
8. Remove the 4 heater assembly
retaining nuts from the dash panel
(engine
compartment).
9. Remove the heater assembly
from the dash panel.
CONNECT
.S'WI".U
WfiUNt;
PLvtiO
10
14CIIT£R
A'"~ro.t
-WI.TCR IIALVC
CAlLI
(All)
FIG. 4- Heater Control.
HEATER ASSEMBLY
INSTALLATION
1. Mount the heater assembly to
the dash panel,
Pasten the
heater in place with the 4 nuts, spring
anq flat
washers.
2. Connect the air vent and temp-
erature control cables
3.
Adjust the control cables and
install the glove box.
4. Replace the left hand air duct
and
cable.
5. Connect the wiring plug and
feed
wire.
6. Refit
demist
nozzle
clips.
7. Connect water hoses.
8. Fill the cooling system.
9.
Bleed the system.
10. Check the operation of the
heater.
HEATER CONTROL ASSEMBLY
REMOVAL
1. Disconnect the wiring plug at
the heater.
2. Disconnect the cables from the
water valve and heater.
3. Remove the instrument cluster
housing.
4.
Remove the control assembly
which is retained by two screws.
INSTALLATION
Installation is the reverse of re-
moval. For adjustments refer to
Section 3.
-
-
\
Advertisement
