Advertisement
EJ
BUCKET SEATS
REMOVAL AND INSTALLATION
FRONT SEAT AND SEAT TRACK
The seat track assembly is easily
replaced if the seat assembly is
removed from the car.
1. From under the car, remove
the seat track reta ining stud nuts
and
washers.
Remove the seat as-
sembly
f
r
om the car and place it
on
a
clean work
area.
2. Remove the nuts which retain
the seat track assembly to
the
cushion and remove the seat track
assembly.
3.
Disconnect
the
release cable
from the track
being
replaced and
conn.
e ct it to a new seat track
.
4.
Place the seat track assembly
PART 18-2- SEATS
on the seat cushion and install the
retaining nuts
5. Place the seat assembly in the
car and install the washers and
nuts on the retaining studs.
FRONT SEAT CUSHION COVER
Repairs to seat cushions or seat
tracks are performed out of the car
and are usually limited to replace-
ment of torn or burned seat cov-
ers. In a few instances, the pads
may be damaged and require re-
placement.
1.
Remove the seat and track as-
sembly from the car and place it
on a clean work area.
2. Remove the seat track
assem-
bly from the seat cushion.
FIG. 6-Bucket Seat Front Typical
18-11
3. Undo the two retaining screws
and remove the side valance.
4. Remove the four hog rings re-
taining seat back lower valance
panel to the seat cushion.
5. Remove the two hog rings re-
taining the
tags
of
the
sleeve
assl!mbly on the reclining mechan-
ism cross bar.
6.
Loosen the screws holding the
reclining hinge assembly to the seat
back and remove the bolts holding
the hinge assembly to the seat cush
-
ion. The cushion may now be de-
tached.
7. Remove the two
sea
t cu shi on
buttons and remove the hog rings
holding the cushion
cover.
8. Turn back the cover and re-
move the surround pad
.
Remove the
Advertisement
