Advertisement
14-16
GROUP 14- STARTING SYSTEM
NOTE: Ensure the long field brush
lead "passes through the arch of the
adjacent earth brush fixing
plate.
(FIG.
6).
5. Assemble the armature and
drive assembly to the drive end
bracket.
6. Assemble the yoke and field
coil assembly to the drive end
bracket.
7.
Assemble the commutator end
bracket and brush gear assembly to
the yoke and field coil assembly. Fit
the through bolts and torque to
specification.
8.
Assemble the field coil/solenoid
linking cable and tighten the nut.
PINION ENGAGING LEVER AD·
JUSTMENT
a.
Disconnect the solenoid lead to
the starter motor field
.
b.
Energise the solenoid with a 6-8
volt
supply.
(6-8 volts is used to prevent solenoid
over
heating).
c.
Using a screw driver in the recess,
turn the pivot pin until the correct
setting of
O.Ql5
±
.005
is obtained
between the pinion face and the
thrust collar.
d.
Fit the lock nut to the eccentric
pivot pjn and lock pin in
position.
DIAGRAM (B)
LONGER FIELD BRUSH LEAD THREADED
THROUGH EARTH
BRUSH TERMINAL
FIG. 6- Commutator end bracket, inside view.
Advertisement
