Advertisement
7-80
GROUP 7-AUTOMATIC TRANSMISSION
THRUST WASHER
8
D1443-A
FIG. 104 - Number 8 Thrust
Washer Location
Do not select a washer that must
be forced between the stator sup-
port and intermediate brake drum.
e. Remove the intermediate brake
drum and forward clutch unit from
the stator support.
f. Install the selected Nos. 1 and
2 thrustwashers on the front pump
stator support
(Fig.
43) using
enough vaseline to hold the thrust
washers in position during the front
pump installation.
24. Install thrust washer No. 3
on the forward clutch (Fig.
107).
25. Install the forward clutch hub
and ring in the forward clutch by
rotating the units to mesh the for-
/
REVERSE-HIGH
CLUTCH
D1439-A
FIG. 106 - Installing Clutch Units
THRUST WASHER NO
.
3
FIG. 1 07 - Number 3 Thrust
Washer Location
THRUST WASHER NO
.
7
.---·
j
REVERSE PLANET CARRIER
THRUST WASHER
NO.
6
D1444-A
FIG. 105- Number 6 and 7 Thrust Washer Location
FORWARD CLUTCH HUB
AND RING GEAR
FORWARD
CLUTCH
D1454-A
FIG. 108 - Installing Forward
Clutch Hub and Ring Gear
FIG. 109 - Number 4 Thrust
Washer Location
ward clutch
plates
with the
splines
on the forward clutch hub (Fig.
108).
26. Install thrust washer No. 4
on the front planet carrier (Fig.
109).
Install the front planet carrier
into the forward clutch hub and
ring gear. Check the forward thrust
bearing race inside the planet carrier
for proper location against the thrust
bearing. Make sure the race is cen-
tered for alignment with the sun
gear on the input shell.
27. Install the input shell and
sun gear on
the
gear train
(Fig.
Ill).
Rotate the input shell to engage the
drive lugs of the reverse-high clutch.
Advertisement
