Advertisement
10-66
CARTER PERMANENn Y
SEALED FUEL PUMPS
DISASSEMBLY
The fuel pump assembly is shown
in Fig. 2.
1. Scrape away the staking mark
and remove the rocker arm pin seal
plug as shown in Fig. 7.
2. Release the tension on the
rocker arm spring pressure
~nd
al-
low the rocker arm pin to fall out. If
the pin does not come out freely, tap
the fuel pump assembly lightly on
the bench until the pin sticks out of
the bore; then, remove the pin with
pliers. Remove the rocker arm and
spring(s).
GROUP 10-
FUEL SYSTEM
CLEANING AND INSPECfJON
Clean and inspect the fuel pump
component parts. Refer to Cleaning
and Inspection (Pagelo-13) for the
proper procedure. Replace all worn
or damaged parts.
ASSEMBLY
The fuel pump assembly is shown
in Fig. 2.
1. Insert the rocker arm spring
into the spring guide bore in the
dome of the fuel pump rocker arm
cavity.
2. Insert the rocker arm into the
cavity and hook it onto the dia-
phragm rod, directly below the rod
ftange.
Position the rocker arm
spring(s) over the spring locater(s)
on the rocker arm. Align the rocker
arm pin holes and install the rocker
arm pin. Make certain the rocker
ann spring(s) Is properly posldoned
on the spring locater on the rocker
arm.
3. Install a new rocker arm pin
plug. Stake the plug into position.
Advertisement
