Advertisement
PART 18-1-
INTERIOR TRIM AND VINYL TOP COVER
18-5
FIG. 2-lnstrument Panel Safety Cover Installation
to the corresponding area of the
roof outside cover assembly. For
best results,
secure
limited
sections
at a time. Make certain that the
adhesive is not lumpy as it
will
be
objectionable from an appear-
ance standpoint.
Stretch out all wrinkles progres-
sively.
4. Drill or punch drive nail holes
at
windshield and
rear
window open-
ings and install drive nails. Existing
holes may be used for the
screws
at
each seam.
5. Trim the
excess cover
material
from
around the entire perimeter.
6. Using a fibre
or
wood block
snap
the outside
cover
retainers into
place in the drip rail trough.
7. Install the drip rail mouldings.
FIG. 3-0utside Cover Installation-
Typical
8. Install the rear and side belt
mouldings.
9. Reposition and
secure
the head-
lining.
10. Install the package tray panel,
rear
seat squab
and cushion.
11. Install the windshield exterior
mouldings.
Advertisement
