Advertisement
FIG.
9 -
Non-Adjustable
Operating Cylinder
All Vehicles
FIG. 1 0-Ciutch Release
Lever and Pivot
PART 5-3-CLUTCH
CLUTCH RELE'ASE LEVER
REMOVAL
The clutch release lever is held
in position on the knife edge pivot
by a
spring
wire clip Fig. 10.
1.
Remove the flywheel housing
as outlined
in
clutch pressure plate
and /or disc
removal.
2.
Using a large screwdriver
through
the transmission input
shaft hole in the flywheel
housing,
prise the release lever retaining
spring from the tang in the knife
edge pivot (Fig. 10).
3.
Remove
the release lever
toward the centre of the flywheel
housing.
FIG. 11-lnstallation Sketch Clutch
Operating Mechanism
5-15
INSTALLATION
1.
Lubricate the
knife edge
pivot recess in
the
release lever
with
grease MJC 75
A.
2.
Locate the
retaining spring
on the release lever
(Fig.
10).
3.
Assemble
the release
lever
in the flywheel housing
with the
knife edge pivot
in
its recess
in the
lever.
Using a
large
screwdriver
through the transmission
input
shaft
hole in the flywheel housing,
lift the release lever retaining
spring
on to the pivot
tang. (Fig. 10).
4.
Install the flywheel housing
as outlined in
clutch
pressure
plate
and/or disc
installation.
r---
.-£'
- -
0
~~
~-
-
~-------~--
.
I -
_:~
-
-
Advertisement
