Advertisement
Seetioa
PART
12·2
12-3
EXHAUST PIPES, MUFFLERS
Pare
Section
1
Description
12-3
2 Removal and Installation
Pare
12-3
D
DESCRIPTION
The exhaust systems for the
various car models are shown in
Figs. 1 to 14.
SINGLE EXHAUST SYSTEMS
The single exhaust system on cars
with a six cylinder engine (Fig.
1)
consists of a muffler inlet pipe,
muffler with integral
inlet
pipe
extension and outlet pipe.
The single exhaust system on cars
with a
V-8
engine (Fig.
2)
consists
of a
Y
-type muffler inlet pipe,
muffler with integral inlet pipe
extension and outlet pipe.
The location and type of exhaust
system gaskets, retaining clamps and
loop-type support brackets are shown
in the respective exhaust system
illustrations. The loop-type support
EJ
REMOVAL AND INSTALLATION
The replacement procedures given
apply to all car models. Typical
exhaust systems for the various
car models are shown in Figs.
1
to 14.
MUFFLER ASS EMILY
REMOVAL
1.
Loosen the inlet pipe clamp at
the front end of the muffler inlet
pipe extension, and slide the clamp
forward onto the inlet pipe.
brackets eliminate tension on the
supports due to
thermal
expansion
of the
system.
DUAL EXHAUST SYSTEM
The dual exhaust
system consists
of an H-type
inlet
pipe and an inlet
pipe extension, muffler, and outlet
pipe for each
side.
2. Loosen the outlet pipe clamp
at the rear end of the muffler, and
retain the clamp on the muffler loop
mount.
3. Loosen the outlet pipe clamp
at the rear loop mount.
Advertisement
