Advertisement
7-58
GROUP 7-AUTOMATIC TRANSMISSION
Column
Shift
,
~--~
it
"f...
(•
I
)\\
,,
.
ti_)
FIG.
23 - Manual Linkage
~~
·~~
..
--\
2. Position
the
transmission
selector
lever
into the
D
position
making
sure
that the selector lever
i-
s
against
the D, stop on the
selector plate.
3. Shift the manual lever at the
transmission into the D detent
position, third
from
the rear.
4. Tighten the clamp on the shift
rod
at
point A.
5. Check the pointer alignment
and transmission operation for all
selector lever detent positions.
CONSOLE SHIFT
Selector Lever Removal and Re-
'"'
placement.
Floor Shift
1. Raise the vehicle and remove
the manual lever control rod (Fig. 23)
2. Lower the vehicle, remove the
selector lever handle attaching screw
a~d
remove the handle. (Fig. 23).
3. Remove the two console attach-
ing screws at the front of the console
and
the
four screws
in the glove box.
Remove the
console and
gear lever
slide
assembly.
4. Detach the dial indicator light.
S. The gear lever slide assembly,
which
incorporates
the dial, may be
detached
from
the
console
by remov-
ing the four attaching screws.
6. Remove the selector housing
and lever assembly attaching bolts
and remove the selector lever and
housing.
7. Remove the selector lever to
housing attaching nut. Remove the
lever from the housing.
8. Install the selector lever in the
housing and install the attaching nut.
Torque the nut to 20 to 25 ft. lbs.
9. Install the selector lever handle.
FIG.
24-
Selector Lever Detent Pawl Adiustment-
Typical
3. Hold the transmission
in full
downshift position against internal
stop.
4. Turn adjustment
screw on the
carburettor kickdown
lever to within
0.040
to
0.080 gap of contacting pick-
up surface
of carburettor throttle
lever. Fig. 26
5.
Release
the
transmission and
carburettor to the
normal free posi-
tion.
6. Install the throttle and down-
shift return springs.
MANUAL LINKAGE
ADJUSTMENT COLUMN SHIFT
1. With
the
engine
stopped,
loosen the clamp at the shift lever
at point A so that the
shift
rod is
free to slide in the clamp
(Fig.
23).
FIG. 25 - Neutral Start Switch
Advertisement
