Ford FALCON XA Series Repair Manual page 200

TABLE 2-
FAULT INVESTIGATION KEY
PRELIMINARY ADJUSTMENT FAULTS
A Fluid level incorrect.
B Downshift valve cable incorrectly assembled or adjusted.
C Manual linkage incorrectly assembled or adjusted.
HYDRAULIC CONTROL FAULTS
a Oil tubes missing or not installed correctly.
b Sealing rings missing or broken.
c Valve body assembly screws missing or not correctly tightened.
d Primary regulator valve sticking.
e Secondary regulator valve sticking.
f Throttle valve sticking.
g Modulator valve sticking.
h Governor valve sticking, leaking or incorrectly assembled.
j
Orifice control valve sticking.
k First to second shift valve sticking.
Second
to
third shift valve sticking.
m Second to third shift valve plunger sticking.
n Converter .. out" check valve missing or sticking.
p Pump check valve missing or sticking.
D Incorrect engine idling speed.
E Incorrect front band adjustment.
F Incorrect rear band adjustment.
MECHANICAL FAULTS
N Front clutch slipping due to worn plates or faulty parts.
0 Front clutch seized or plates distorted.
P Rear clutch slipping due to worn plates or faulty check valve
in piston.
Q Rear clutch seized or plates distorted.
R Front band slipping due to faulty servo, broken or worn band.
S Rear band slipping due to faulty servo, broken or worn band.
T One-way clutch slipping or incorrectly installed.
U One-way clutch seized.
V Input shaft broken.
W Pump drive tangs on converter hub broken.
X Pump worn.
Z Converter blading and/or one-way clutch failed.
.,
)>
;10
-t
~
-
)>
c
--i
~
)>
--i
n
--i
;;o
)>
z
~
~
0
z
-
O J
0
..,
(Q
~
01
..,
::J
(I)
.., -
' : ' 4
-
. ......,