Advertisement
PART 4-3-SPKfiCAnONS
REMOVABLE CARRIER TRACTION LOK
NOTE: All specifications are civen in inches unless otherwise noted.
Backlash between ring qear and pinion
0
.
008-0. 012
Maximum backlash variation between teeth
Maximum runout of backface of ring gear
Differential side gear thrust washer thickness
Differential pinion gear thrust washer thickness
Nominal pinion locating shim
Available pinion gear shims in steps of
.
001
Maximum radial runout of U joint flange in assembly
•Minimum torque required to tighten pinion flange nut to obtain correct pinion
bearing preload
Pinion bearing preload original
bearings.
with oil seal
Pinion bearing preload new bearings. with oil seal
Minimum rotating torque required to turn axle shaft and side gear with one
wheel on ground
0 .003
0 .003
0 .030-0.032
0 .030-0
.
032
0 .015
0 .010-0 .029
0 .010T.I.R.
175
lbs.
ft.
8-14 lbs.
in.
22-32
lbs.
in.
40 lbs. ft.
40 lbs.
ft.
min.
4-29
tRotating torque required during bench check after assembly
original clutch plates
new clutch plates
1 00-250
lbs.
ft.
•If pinion bearing preload exceeds specification before this torque is obtained. install a new
spacer.
tRotating torque may fluctuate up to 40
lbs.
ft.
TORQUE LIMITS INTEGRAL CARRIER AXLES
Torque Umm
Rear Cover Bolts
Differential Bearing Cap Screws
Drive Pinion Nut (Minimum Torque)
Ring Gear Attaching Bolts
Rear Springs to Axle Housing U Bolts
Universal Joint Bolt Nuts
Axle Identification 199071 199072 199073
199069 199070
Rear Shock Absorber to Rear Spring
Clip Plate Assembly Nuts
Axle Shaft Bearing Retainer Nuts
Pinion Bearing Preload (Including Oil Seal Drag)
Differential Assembly Pre·Load (Pull Measured
From String Wrapped Around the Differential Case
larger Diameter
REMOVABLE CARRIER TRACTION LOK
Differential bearing cap bolt
Differential bearing adjusting nut lock bolts
Carrier to housing stud nuts
Pinion retainer to carrier bolts
Ring gear attaching bolts
Oil filler plug
Rear axle shaft bearing retainer bolt nuts
Ft.
Lbs.
20- 25
35-45
240-280
40-
so
35-
so
12- IS
7- 10
IS- 25
IS- 25
30-35
IS-301b. ins.
3.31b. Min.
b.Sib. Max.
70-85 lbs. ft.
1 2-25 lbs. ft.
25-40
lbs.
ft.
30-45
lbs.
ft.
65-80 lbs. ft.
25-50
lbs.
ft.
30-35
lbs.
ft.
Advertisement
