Completing Installation And Cabling Of The Cts 1100 - Cisco TelePresence System 1100 Assembly Manual

Chapter 3 Assembling and Mounting a Cisco TelePresence System 1100

Completing Installation and Cabling of the CTS 1100

To perform the final installation tasks and route and attach the cables for the CTS 1100, complete the
steps in the following section.
Install the codec into the cabinet by completing the following steps:
Step 1
a.
b.
Note
c.
Note
OL-19695-01
Insert the codec into the right side of the cabinet.
Arrange the codec so that its power outlet is on the left as shown in
Slide the codec from the left to the right left until the top of the codec slides past the spring-loaded
posts inside the cabinet.
In some cases, you might have to lift the posts and turn them counter-clockwise prior to
installation.
Turn the posts clockwise to lower the posts and lock the codec into place.
If you have a presentation codec, place the presentation codec into the left side of the cabinet,
with the power outlet pointing to the right. Refer to the
System 1100" chapter of the
more information. Note that an external presentation display is required for use with a
presentation codec.
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
Completing Installation and Cabling of the CTS 1100
Cisco TelePresence Hardware Options and Upgrade Guide
Figure 3-36.
"Options for the Cisco TelePresence
for
3-45