Parameters For Ldap Directory - Cisco 8800 Series Manual

Parameters for LDAP Directory

Some sites might not deploy DNS internally and instead use Active Directory 2003. In this case, it is not
necessary to enter a Primary DNS address and an LDAP Domain. However, with Active Directory 2003, the
authentication method is restricted to Simple.
You can configure this parameter in the configuration file by entering a string in this format:
<Domain ua="na">LDAPdomainname.com</Domain>
Step 4
Click the Phone tab.
Step 5 Configure the LDAP fields as described in
Step 6
Click Submit All Changes.
Parameters for LDAP Directory
The following table defines the function and usage of the LDAP directory parameters in the LDAP section
under the Voice > Phone tab in the phone web interface. It also defines the syntax of the string that is added
in the phone configuration file (cfg.xml) with XML code to configure a parameter.
Table 61: Parameters for LDAP Directory
Parameter
LDAP Dir Enable
Corp Dir Name
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
296
Parameters for LDAP Directory, on page
Description
Enables or disables the LDAP directory.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<LDAP_Dir_Enable ua="na">Yes</LDAP_Dir_Enable>
• In the phone web interface, set this field to Yes or No to enable or disable LDAP
directory.
Allowed values: Yes|No
Default: No
Enter a free-form text name, such as "Corporate Directory".
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<LDAP_Corp_Dir_Name ua="na">Coprorate Directory</LDAP_Corp_Dir_Name>
• In the phone web interface, enter the name of the corporate direcotry.
Allowed values: Text string with no more than 63 characters
Default: Empty
Cisco IP Phone Configuration
296.