Access Control Configuration; Access Control; Administrator And User Accounts - Cisco 8800 Series Manual

Access Control Configuration

•
•
•
•
•
•

Access Control

If the <Phone-UI-User-Mode> parameter is enabled, the phone GUI honors the user access attribute of the
relevant parameters when the GUI presents a menu item.
For menu entries that are associated with a single configuration parameter:
• Provisioning the parameter with "ua=na" ("ua" stands for "user access") attribute makes the entry
• Provisioning the parameter with "ua=ro" attribute makes the entry read-only and non-editable.
For menu entries that are associated with multiple configuration parameters:
• Provisioning all concerned parameters with "ua=na" attribute makes the entries disappear.

Administrator and User Accounts

The Cisco IP Phone firmware provides specific administrator and user accounts. These accounts provide
specific login privileges. The administrator account name is admin; the user account name is user. These
account names cannot be changed.
The admin account gives the service provider or Value-added Reseller (VAR) configuration access to the
Cisco IP phone. The user account gives limited and configurable control to the device end user.
The user and admin accounts can be password protected independently. If the service provider sets an
administrator account password, you are prompted for it when you click Admin Login. If the password does
not yet exist, the screen refreshes and displays the administration parameters. No default passwords are assigned
to either the administrator or the user account. Only the administrator account can assign or change passwords.
Access Control, on page 103
Administrator and User Accounts, on page 103
User Access Attribute, on page 104
Access the Phone Web Interface, on page 104
Control Access to the Phone Settings, on page 105
Bypass the Set Password Screen, on page 108
disappear.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
7
C H A P T E R
103