Headset Configuration On Your Phone; Cisco Headset 500 Series Customization; Set The Upgrade Rule For The Cisco Headset 500 Series - Cisco 8800 Series Manual

Cisco IP Phone Accessories
Depending on the quality of headsets and their proximity to other devices, such as mobile phones and two-way
radios, some audio noise or echo may still occur. Either the remote party or both the remote party and the
Cisco IP Phone user may hear an audible hum or buzz. A range of outside sources can cause humming or
buzzing sounds; for example, electric lights, electric motors, or large PC monitors.
Note
Sometimes, use of a local power cube or power injector may reduce or eliminate hum.
Environmental and hardware inconsistencies in the locations where Cisco IP Phones are deployed mean that
no single headset solution is optimal for all environments.
We recommend that customers test headsets in the intended environment to determine performance before
making a purchasing decision to deploy on a large scale.
You can use only one headset at a time. The most-recently connected headset is the active headset.

Headset Configuration on Your Phone

Cisco Headset 500 Series Customization

The user can customize the headset's gain or microphone volume, sidetone or feedback settings, and test the
microphone. Make sure that the headset is connected to the phone using one of the following connections:
• Cisco Headset 520 Series with the inline USB controller via the USB connector
• Cisco Headset 531 and 532 with the USB adapter via the USB connector
• Cisco Headset 560 Series Standard Base or Multibase with the Y-cable via the AUX and the RJ-9

Set the Upgrade Rule for the Cisco Headset 500 Series

You can upgrade the firmware in the Cisco Headset 500 Series. The headset settings are not erased by a phone
reset. The upgrade rule supports HTTP and TFTP protocols.
We provide you with the headset XML file. If the software version in the file is later than the firmware on
the headset, the user is prompted to upgrade the headset on the phone screen. The user can choose to upgrade
the headset immediately or postpone it to a later time.
Before you begin
Access the phone administration web page. See
Procedure
Step 1 Click Voice > Provisioning.
Step 2
Select the Cisco Headset Upgrade Rule parameter found in the Cisco Headset Firmware Upgrade section.
Step 3
Specify the TFTP or HTTP protocol, an IP address of the headset upgrade device, and the name of the headset
XML file. Enter the values as a single string in the Cisco Headset Upgrade Rule field.
Caution
connectors, or with the USB cable via the USB connector
Do not change the headset XML file contents.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
Headset Configuration on Your Phone
Access the Phone Web Interface, on page 104.
471