Cisco 8800 Series Manual page 114

Data Types
• on
• D
All durations can have up to three decimal places to provide 1 ms resolution. The wildcard character "*"
stands for infinite duration. The segments within a section are played in order and repeated until the total
duration is played.
Example 1:
60(2/4)
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 60 s
Number of Segments = 1
Segment 1: On=2s, Off=4s
Total Ring Length = 60s
Example 2—Distinctive ring (short,short,short,long):
60(.2/.2,.2/.2,.2/.2,1/4)
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 60s
Number of Segments = 4
Segment 1: On=0.2s, Off=0.2s
Segment 2: On=0.2s, Off=0.2s
Segment 3: On=0.2s, Off=0.2s
Segment 4: On=1.0s, Off=4.0s
Total Ring Length = 60s
• DialPlanScript—Scripting syntax that is used to specify Line 1 and Line 2 dial plans.
• Float<n>—A floating point value with up to n decimal places.
• FQDN—Fully Qualified Domain Name. It can contain up to 63 characters. Examples are as follows:
• sip.Cisco.com:5060 or 109.12.14.12:12345
• sip.Cisco.com or 109.12.14.12
• FreqScript—A miniscript that specifics the frequency and level parameters of a tone. Contains up to 127
characters.
Syntax: F
• F
• L
White spaces before and after the comma are allowed but not recommended.
Example 1—Call Waiting Tone:
440@-10
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
94
and off are the on/off duration in seconds of a segment. i = 1 or 2, and j = 1 to 6.
i,j i,j
is the total duration of the section in seconds.
i
@L [,F @L [,F @L [,F
1 1 2 2 3 3
–F are frequency in Hz (unsigned integers only).
1 6
–L are corresponding levels in dBm (with up to one decimal place).
1 6
@L [,F @L [,F @L ]]]]], where:
4 4 5 5 6 6
Cisco IP Phone Provisioning