Cisco 8800 Series Manual page 72

Profile Resync Parameters
Parameter
Resync From SIP
Resync After
Upgrade Attempt
Resync Trigger 1
Resync Trigger 2
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
52
Description
Controls requests for resync operations via a SIP NOTIFY event sent from the service
provider proxy server to the phone. If enabled, the proxy can request a resync by
sending a SIP NOTIFY message containing the Event: resync header to the device.
• In the phone configuration file (cfg.xml) with XML, enter a string in this format:
<Resync_From_SIP ua="na">Yes</Resync_From_SIP>
• On the phone web page, select Yes to enable this feature, or No to disalbe it.
Default: Yes
Enables or disables the resync operation after any upgrade occurs. If Yes is selected,
sync is triggered after a firmware upgrade.
• In the phone configuration file (cfg.xml) with XML, enter a string in this format:
<Resync_After_Upgrade_Attempt
ua="na">Yes</Resync_After_Upgrade_Attempt>
• On the phone web page, select Yes to trigger resync after a firmware upgrade,
or No to not resync.
Default: Yes
If the logical equation in these parameters evaluates to FALSE, resync is not triggered
even when Resync On Reset is set to TRUE. Only the resync via direct action URL
and SIP notify ignores these resync triggers.
The parameters can be programmed with a conditional expression that undergoes macro
expansion. For the valid macro expansions, see
73.
• In the phone configuration file (cfg.xml) with XML, enter a string in this format:
<Resync_Trigger_1 ua="na">$UPGTMR gt 300 and $PRVTMR ge
600</Resync_Trigger_1>
<Resync_Trigger_2 ua="na"/>
• On the phone web page, specify the triggers.
Default: Blank
Cisco IP Phone Provisioning
Macro Expansion Variables, on page