Cisco 8800 Series Manual page 91

Cisco IP Phone Provisioning
Parameter Name
Resync After Upgrade Attempt
Resync Trigger 1, Resync Trigger 2
Resync Fails On FNF
Profile Rule
Profile Rule B
Profile Rule C
Profile Rule D
DHCP Option To Use
Log Request Msg
Log Success Msg
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
Configuration Profile Parameters
Description and Default Value
Enables or disables the resync operation after any
upgrade occurs. If Yes is selected, sync is triggered.
The default value is Yes.
Configurable resync trigger conditions. A resync is
triggered when the logic equation in these parameters
evaluates to TRUE.
The default value is (empty).
A resync is considered unsuccessful if a requested
profile is not received from the server. This can be
overridden by this parameter. When it is set to no, the
device accepts a
file-not-found
server as a successful resync.
The default value is Yes.
Each profile rule informs the phone of a source from
which to obtain a profile (configuration file). During
every resync operation, the phone applies all the
profiles in sequence.
Default: /$PSN.xml
If you are applying AES-256-CBC encryption to the
configuration files, specify the encryption key with
the --key keyword as follows:
[--key <encryption key>]
You can enclose the encryption key in double-quotes
(") optionally.
DHCP options, delimited by commas, used to retrieve
firmware and profiles.
The default value is 66,160,159,150,60,43,125.
This parameter contains the message that is sent to
the syslog server at the start of a resync attempt.
The default value is $PN $MAC –Requesting
% $SCHEME://$SERVIP:$PORT$PATH.
The syslog message that is issued upon successful
completion of a resync attempt.
The default value is $PN $MAC –Successful
Resync %
$SCHEME://$SERVIP:$PORT$PATH -- $ERR.
response from the
71