Set Up A Phone For Remote Sdk - Cisco 8800 Series Manual

Cisco IP Phone Configuration
Field and Description
Parking Lot Busy LED—The monitored line has a
parked call.
The following table describes the LED behavior for the Busy Lamp Field (BLF) feature. The table compares
the Default and Preset 1 settings.
Table 43: BLF Feature Settings
Field and Description
BLF Idle LED—The monitored line
is idle.
BLF Ringing LED—The monitored
line is ringing.
BLF Busy LED—The monitored
line is busy in a call.
BLF Held LED—The monitored
line has put a call on hold.
Applies to phone line keys, only:
BLF Busy LED applies to key
expansion module line keys.
After you configure a phone with custom LED behavior, and you downgrade it to an older Firmware version,
the custom LED settings remain. If you wish to remove the custom LED settings, then set the LED behavior
to the system default before you perform the downgrade.

Set Up a Phone for Remote SDK

You can configure remote SDK for a multiplatform phone. The remote SDK provides a WebSocket based
protocol through which the phone can be controlled.
Before you begin
•
• A WebSocket server must be running with an address and port reachable from the phone.
Access the Phone Web Interface, on page 104
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
Default Pattern and
Color
Slower blinking red
Default Pattern and Color
Solid green
Fast blink red
For the key expansion module, it is
Slow blink red because the key
expansion module is limited to:
• ON
• OFF
• Slow Blink
Solid red
Slow blink red
Set Up a Phone for Remote SDK
Preset 1 Pattern and
Color
Blinking red
Preset 1 Pattern and Color
Off
Blinking amber
Solid red
Solid red
225