Cisco 8800 Series Manual page 335

Cisco IP Phone Installation
Table 64: Ethernet Configuration Submenu
Field Field Type
or Choices
802.1x Device
authentication authentication
Transaction status
Switch port config Auto
10MB half
10MB full
100MB half
100MB full
1000 full
PC port config Auto
10MB half
10MB full
100 MB half
100MB full
100 half
1000 full
CDP On
Off
Default
Off
Disabled
Auto
Auto
On
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
Description
Enables or disables the 802.1x authentication. Valid options are:
• On
• Off
• Transaction status—Indicates different authentication status
when you turn on 802.1x in the Device authentication field.
• Connecting: Indicates that the authentication process
is in progress.
• Authenticated: Indicates that the phone is authenticated.
• Disabled: Indicates that 802.1x authentication is
disabled on the phone.
• Protocol—Displays the protocol of the server.
Select speed and duplex of the network port.
If the phone is connected to a switch, configure the port on the
switch to the same speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you must change the PC
Port config option to the same setting.
Select Speed and duplex of the Computer (access) port.
If the phone is connected to a switch, configure the port on the
switch to the same speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you must change the
Switch Port config option to the same setting.
Enable or disable Cisco Discovery Protocol (CDP).
CDP is a device-discovery protocol that runs on all Cisco
manufactured equipment.
Using CDP, a device can advertise its existence to other devices
and receive information about other devices in the network.
Network Configuration Fields
315