Table of Contents
Advertisement
Setting up Measurement Conditions and Display
Configuring the GPIB Address
Configuring the GPIB Address
Functional description
Before you can control the E4981A by issuing SCPI commands from an external
controller connected via its GPIB connector, you have to configure the GPIB
address of your E4981A. For information on the concept and implementation of
automatic configuration by use of GPIB, refer to Programming Manual.
To configure the GPIB address:
Step 1.
Press [System].
Step 2.
Press the SYSTEM CONFIG softkey.
Step 3.
Use the cursor keys to select the GPIB ADDR field.
Step 4.
Enter a value with the entry keys in the range of 0 through 30.
Configuring the LAN IP Address
Functional description
To enable the E4981A to communicate over a local area network (LAN), you
have to configure its IP address and connect a LAN cable. The IP address can
be either automatically obtained or manually configured.
When the IP address is set to AUTO, AUTO-IP address is set. When the IP
address is set to MANUAL, the address manually configured is set.
For information on the concept and implementation of automatic configuration
by use of a LAN, refer to Programming Manual.
Softkey
AUTO
MANUAL
Table 4-6
IP address configuration methods
Method
AUTO-IP
MANUAL
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Description
Automatically obtains the IP address.
Manually configures the IP address.
Description
You can automatically obtain an available IP address.
You can manually configure the IP address as well as subnet mask and
gateway settings.
1. Consult your network administrator for relevant settings of your network.
1
73
Advertisement
Table of Contents
