Ending Handler Interface Test - Keysight E4981A User Manual

Using Handler Interface
Control/Check the Handler Interface for Maintenance
•
•
For more information about Handler Test commands, refer to the Keysight
E4981A Programming Manual.

Ending Handler interface test

When the Handler interface test is finished, close the E4981A Handler
interface test mode by setting :TEST:HANDler:MODE command value to OFF
so that handler interface pin signal is generated according to the actual
measurement result.
152
:TEST:HANDler:STATus:RDYTrig sets the Handler Ready for Trigger signal to
HIGH/LOW.
:TEST:HANDler:TRIGger? gets the Handler Trigger signal status as
HIGH/LOW.
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter