Table of Contents
Advertisement
Setting up Measurement Conditions and Display
Configuring the LAN IP Address
Once you have automatically obtained an IP address, you can check the
following monitor areas in the SYSTEM CONFIG page to see the address,
subnet mask, and gateway:
•
•
•
To automatically obtain the IP address:
Step 1.
Press [System].
Step 2.
Press the SYSTEM CONFIG softkey.
Step 3.
When you want to obtain the IP address automatically, select the IP CONFIG
field using the cursor keys and then press the AUTO softkey.
To manually configure the IP address:
Step 1.
Press [System].
Step 2.
Press the SYSTEM CONFIG softkey.
Step 3.
Use the cursor keys to select the IP CONFIG field and then press the MANUAL
softkey.
Step 4.
Use the cursor keys to select the MANUAL IP ADDR field.
Step 5.
Enter the IP address using the entry keys.
Example: 192.168.1.101
Step 6.
Press the ENTER softkey.
Step 7.
Use the cursor keys to select the MANUAL SUBNET MASK field.
Step 8.
Enter the subnet mask using the entry keys.
Step 9.
Press the ENTER softkey.
Step 10.
Use the cursor keys to select the MANUAL GATEWAY field.
Step 11.
Enter the gateway using the entry keys.
Step 12.
Press the ENTER softkey.
Step 13.
Press the RESTART NETWORK softkey.
74
CURRENT IP ADDR
CURRENT SUBNET MASK
CURRENT GATEWAY
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Advertisement
Table of Contents
