Ending Scanner Interface Test - Keysight E4981A User Manual

Using Scanner Interface
Control/Check the Scanner Interface for Maintenance
•
For more information about Scanner Test commands, refer to the Keysight
E4981A Programming Manual.

Ending Scanner interface test

When the Scanner interface test is finished, close the E4981A Scanner
interface test mode by setting :TEST:SCANner:MODE command value to OFF
so that scanner interface pin signal is generated according to the actual
measurement result.
166
:TEST:SCANner:TRIGger? gets the Scanner Trigger signal status as
HIGH/LOW.
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter